| Pin No. | Type | Description |
| 1 | COMP | DAC Bias Pin. This pin is used for decoupling the DAC bias voltage. |
| 2 | VDD | Positive Power Supply for the Analog and Digital Interface Sections. The on-board 2.5 V regulator is also supplied from VDD. VDD can have a value from 2.3 V to 5.5 V. A 0.1 μF and a 10 μF decoupling capacitor should be connected between VDD and AGND. |
| 3 | CAP/2.5V | The digital circuitry operates from a 2.5 V power supply. This 2.5 V is generated from VDD using an on-board regulator when VDD exceeds 2.7 V. The regulator requires a decoupling capacitor of 100 nF typical, which is connected from CAP/2.5V to DGND. If VDD is less than or equal to 2.7 V, CAP/2.5V should be tied directly to VDD. |
| 4 | DGND | Digital Ground. |
| 5 | MCLK | Digital Clock Input. DDS output frequencies are expressed as a binary fraction of the frequency of MCLK. This clock determines the output frequency accuracy and phase noise. |
| 6 | SDATA | Serial Data Input. The 16-bit serial data-word is applied to this input. |
| 7 | SCLK | Serial Clock Input. Data is clocked into the AD9833 on each falling edge of SCLK. |
| 8 | FSYNC | Active Low Control Input. FSYNC is the frame synchronization signal for the input data. When FSYNC is taken low, the internal logic is informed that a new word is being loaded into the device. |
| 9 | AGND | Analog Ground. |
| 10 | VOUT | Voltage Output. The analog and digital output from the AD9833 is available at this pin. An external load resistor is not required because the device has a 200Ω resistor on-board. |
| Attribute | Value |
| Brand: | Analog Devices |
| Product Category: | Data Acquisition ADCs/DACs - Specialised |
| RoHS: | Yes |
| Series: | AD9833 |
| Package/Case: | MSOP-10 |
| Product: | Direct Digital Syntheses |
| Type: | Waveform Generator |
| Resolution: | 10 bit |
| Number of Channels: | 1 Channel |
| Supply Voltage - Min: | 2.3 V |
| Supply Voltage - Max: | 5.5 V |
| Minimum Operating Temperature: | - 40 C |
| Maximum Operating Temperature: | + 105 C |
| Development Kit: | EVAL-AD9833SDZ |
| Interface Type: | Serial |
| Number of Converters: | 1 Converter |
| SNR - Signal to Noise Ratio: | 60 dB |
If you do not receive it within 5 minutes, please check your spam folder or contact us via the website.